CRUISE CONTROL – Hummer H2 2007 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Hummer H2 2007

List of elements for Cruise Control Wiring Diagram for Hummer H2 2007:

• 5v ref
• Accelerator pedal position sensor (below left side of dash)
• App sensor 1 sig
• App sensor 2 sig
• C2 a10
• Class 2 data
• Computer data lines system
• Cruise control on/off switch
• Cruise fuse 10a
• Cruise ind
• Cruise on sw sig
• Etc/ecm fuse 15a
• F12
• G104 (at top left rear of engine)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• I/p fuse block (on lower left side of dash)
• Ign
• Ign volt
• Instrument panel cluster (ipc)
• Logic
• Low ref
• Nca
• On/off
• Pnk
• Power distribution system
• Powertrain control module (pcm) (on left front of engine compt)
• Resume/ accel
• Resume/accel sig
• S102
• Serial data
• Set/ coast
• Set/coast sig
• Stop lamp switch (on top of brake pedal bracket)
• Stop lp fuse 25a
• Tac motor cntrl 1
• Tac motor cntrl 2
• Tan
• Throttle actuator control (tac) module (at left rear of engine compt)
• Throttle body (top of engine, mounted to front of intake manifold)
• Tp sensor 1 sig
• Tp sensor 2 sig
• Turn signal/ multifunction switch
• Under- hood fuse block (at left side of engine compt, near battery)
• Underhood fuse block (at left side of engine compt, near battery)
• Veh stop fuse 15a
• Vehicle speed sensor (vss) (on rear of transfer case assembly)
• Vss high
• Vss low