CRUISE CONTROL – Hyundai Sonata GLS 1998 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Hyundai Sonata GLS 1998

List of elements for Cruise Control Wiring Diagram for Hyundai Sonata GLS 1998:

• (2.0l)
• (3.0l)
• A/t
• A/t shift lever
• Brake switch
• Control valve
• Cruise clutch pedal position switch (below left side of dash, on clutch pedal support)
• Cruise control actuator (on right rear of engine compt, near strut tower)
• Cruise control module (behind center of dash)
• Cruise control switch
• Cruise ctl ind
• Cruise ind
• Cruise on ind
• Cruise switch
• Dash fuse box (under left side of dash, at kick panel)
• Data link connector (on left side
• Diagnosis
• Diode z01
• Engine controls system
• Exterior lights system
• Fuse 2 15a
• Fuse 20 10a
• Fuse 22 10a
• Fuse 8 10a
• G202 (upper left side of dash)
• G206 (below center of dash)
• Ground
• Hot at all times
• Hot in on
• Hot in on or start
• I16-2
• I16-3
• Instrument cluster
• Instrument cluster system
• Interior lights system
• Lower center of dash, above accelerator pedal) m31-1
• M/t
• Multifunction switch
• N d
• Nca
• O/d on input
• Off
• Overdrive switch
• Power
• Prk/neutrl in
• Release valve
• Resume/ accel
• Resume/accel
• Set/ coast
• Set/coast
• Shift interlock system
• Speed sensor
• Starting/ charging system
• Stop lamp sw
• Stop lamp switch
• Tcm
• Transaxle control module (behind center of dash)
• Transaxle range switch (on lower right side of engine compt, on top of transaxle)
• Transmissions system
• Vacuum motor