CRUISE CONTROL – Isuzu Rodeo S 1998 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

3.2L

3.2L, Cruise Control Wiring Diagram for Isuzu Rodeo S 1998

List of elements for 3.2L, Cruise Control Wiring Diagram for Isuzu Rodeo S 1998:

• (a/t)
• (below center console) g302
• (m/t)
• A/t
• A/t gear position switch (beneath center of vehicle, on left side of transmission)
• A10
• A11
• A12
• A13
• Actuator control
• Actuator rel input
• B26
• Brake switch (behind dash, on brake pedal support)
• Brake switch input
• C23
• Cancel
• Cancel input
• Clutch switch (on clutch pedal support)
• Combination switch
• Cruise "on" indicator
• Cruise control actuator (on right side of engine compartment, on inner fender panel)
• Cruise control main switch
• Cruise control main switch light
• Cruise control switch
• Cruise control unit (under rear of center console)
• Cruise on input
• Cruise set indicator light
• Dash fuse box (behind dash, left of steering column)
• Drive input
• Engine control module (ecm) or powertrain control module (pcm) (below center of dash)
• F10
• Fuse 11 meter 15a
• Fuse 14 back up/ turn light 15a
• Fuse 15 elec. ign. 15a
• Fuse 6 stop light 15a
• Gauge assembly
• Ground
• Honda
• Hot at all times
• Hot in on
• Hot in on or start
• I-1
• I-2
• I-9
• Ignition
• Indicator control
• Interior lights system
• Isuzu
• M/t
• Off
• On input
• Red
• Res/ acc
• Resume/accel input
• Set coast
• Set/coast input
• Speedometer
• Vehicle speed sensor (vss) (beneath center of vehicle, rear of transmission)
• Vss input