CRUISE CONTROL – Isuzu Rodeo S 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

3.2L

3.2L, Cruise Control Wiring Diagram for Isuzu Rodeo S 2003

List of elements for 3.2L, Cruise Control Wiring Diagram for Isuzu Rodeo S 2003:

• (below center of dash) immobilizer control unit
• (left rear of engine compt)
• Acceleration position sensor assembly (above accelerator pedal)
• Acceleration sensors
• Ap sen1 gnd
• Ap sen2 gnd
• Ap sensor 1
• Ap sensor 2
• Ap sensor 3
• Aps3 gnd
• B-19
• Brake sw in
• Brake switch (behind left side of dash, on brake pedal support)
• C-52
• C16 (at left rear corner of engine compt, on inner fender panel)
• Cancel
• Cancel in
• Cb-11 meter fuse 15a
• Cb-12 engine ig fuse 15a
• Cb-14 back-up/ turn light fuse 15a
• Cb-6 stop light fuse 15a
• Clutch switch (m/t) (behind left side of dash, on clutch pedal support)
• Cruise brake
• Cruise control main switch
• Cruise control switch
• Cruise lmp
• Cruise set light
• Cruise sw
• Dash fuse box (behind left side of dash, behind panel)
• Drive input
• E-21
• E-22
• E28 (at left side of intake manifold)
• E30 (at right side of intake manifold)
• Eb-17 ecm fuse 30a
• Ecm or pcm main relay
• Engine control module (ecm) or powertrain control module (pcm)
• Fuse/relay box (on right side of engine compt)
• Gnd
• Hot at all times
• Hot in on or start
• I-2
• I-55
• I-9
• Ign
• Ign feed
• Illumination
• Ind on/off cruise
• Intelligent suspension control unit (below center of dash)
• Interior lights system
• Meter assembly
• Nca
• On switch
• Pnk
• Red
• Ref volt
• Res/acc
• Set/cst
• Solid state sensor
• Speedometer
• Srs coil assembly
• Steering wheel
• Switch unit a
• Th val mtr+
• Throttle position sensor 1
• Throttle position sensor 2
• Throttle val-
• Throttle valve assembly
• Throttle valve motor
• Tps 1 sign
• Tps1 gnd
• Tps2 gnd
• Tps2 sign
• Transfer control unit (below center console)
• Vehicle speed sensor (beneath center of vehicle, rear of transmission)
• Vss in