CRUISE CONTROL – Jeep Commander Sport 2010 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Jeep Commander Sport 2010

List of elements for Cruise Control Wiring Diagram for Jeep Commander Sport 2010:

• (left rear of engine compt)
• 3.7l
• 5.7l
• A108
• Accelerator pedal position sensor (left side of dash)
• Apps 1 sens rtn
• Apps 1 sig
• Apps 2 sens rtn
• Apps 2 sig
• B15
• B16
• Brake sw 1 sig
• Brake sw 2 sig
• Brk sw 1 sig
• Brk sw 2 sig
• C107
• C200
• Can b bus (+)
• Can b bus (-)
• Can bus (+)
• Can bus (-)
• Cluster
• Computer data lines system
• D64
• D65
• Engine controls system
• Etc motor (+)
• Etc motor (-)
• F855
• F856
• Fuse 10a
• Fused b(+)
• G100
• G200
• Gnd
• Ground
• Hot at all times
• Hot in run or start
• Ign rs
• Input speed sensor (5.7l) (left side of transmission)
• Input speed sig
• Junction block (left side of dash)
• K122
• K124
• K126
• K167
• K22
• K23
• K29
• K400
• K922
• Output speed sensor (5.7l)
• Output speed sig
• Powertrain control module (right rear of engine compt)
• Red
• Right steering wheel switch
• S/c sw return
• S/c sw rtn
• S/c sw sens 2
• S/c sw sense 1
• S/c sw sense 2
• S106
• S134 (except 5.7l 4wd)
• S139
• S140
• S144
• S212
• S228
• Sens rtn
• Speed control switch
• Steering control module
• Stop lamp switch (left side of dash)
• T13
• T14
• T52
• Throttle body (top front of engine)
• Tp 1 sig
• Tp 2 sig
• Tp sensor rtn
• V71
• V72
• V937
• Z907