CRUISE CONTROL – Jeep Grand Cherokee Limited 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Jeep Grand Cherokee Limited 2005

List of elements for Cruise Control Wiring Diagram for Jeep Grand Cherokee Limited 2005:

• (5.7l)
• (5.7l: right rear of engine) (3.7l & 4.7l: right side of engine)
• (near breakout to data link connector) g200
• (on steering wheel) s201
• (on steering wheel) s218
• 3.7l
• 3.7l/4.7l
• 4.7l
• 5.7l
• A108
• Engine controls system
• Etc motor (+)
• Etc motor (-)
• F855
• Fuse 10a
• Fused b (+)
• G103 (in headlamp & dash harness)
• Ground
• Hot at all times
• Junction block (left side of dash)
• K122
• K124
• K126
• K22
• K900
• K922
• Left speed control switch
• Powertrain control module (right rear of engine compartment)
• Right speed control switch
• S/c sw rtn
• S/c sw sense 1
• S/c sw sense 2
• S/c sw sig 1
• S/c sw sig 2
• S/c vacuum solenoid ctrl
• S/c vent solenoid ctrl
• S111
• S139 (4.7l: right rear of engine) (3.7l: rear of engine) (5.7l: right rear of engine compt)
• S200 (on steering wheel)
• S212
• S228
• Sensor ground
• Speed control servo (3.7l, 4.7l) (right rear of engine compartment)
• Steering control module (at steering wheel)
• Stop lamp switch (lower left side of dash)
• Throttle body (5.7l) (top front of engine)
• Throttle position sensor (3.7l, 4.7l) (top of engine)
• Tp sens 1 sig
• Tp sens 2 sig
• Tp sensor 1 sig
• Tp sensor 2 sig
• Tp sensor rtn
• V32
• V35
• V36
• V371
• V372
• V397
• V71
• V72
• V937
• Vacuum
• Vent
• Z907