CRUISE CONTROL – Jeep Grand Cherokee TSi 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Jeep Grand Cherokee TSi 1997

List of elements for Cruise Control Wiring Diagram for Jeep Grand Cherokee TSi 1997:

• (4.0l: engine harness,
• (4.0l: engine harness, near branch to pcm)
• (5.2l: engine harness, right rear of engine)
• (behind
• B27
• B31
• C11
• C24
• C32
• Cancel
• Clock- spring
• Coast
• G107 right headlamp)
• G300 driver's seat)
• Ground
• K95
• L53
• Left switch
• Nca
• On/ off
• Pnk
• Powertrain control module (rear of right front fender)
• Red
• Resume/ accel
• Right switch
• S105
• S131 in branch to transmission) (5.2l: engine harness, right rear of engine)
• S132 in branch to transmission) (5.2l: engine harness, right rear of engine)
• S135
• S202
• Sensor grd
• Sensor ground
• Set
• Speed ctrl res
• Stop lamp switch (top of brake pedal switch)
• Stop lamp switch sense
• Stop sw
• Tan/red
• V32
• V35
• V36
• Vac solenoid
• Vacuum ctrl
• Vehicle speed control servo (right side of safety wall)
• Vehicle speed control/ horn switches
• Vehicle speed sensor (rear of transfer case)
• Vent ctrl
• Vent solenoid
• Vsc sw signal
• Vss signal