CRUISE CONTROL – Mercury Tracer 1994 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Mercury Tracer 1994

List of elements for Cruise Control Wiring Diagram for Mercury Tracer 1994:

• (behind left top
• (behind right cowl panel)
• (behind top left side of i/p
• (left side of
• (lower rear of
• (near wiper motor)
• (on brake
• (on clutch
• (on steering wheel
• (right front
• (top left front
• 1.8l
• 1.9l
• 110/140
• 15a
• 20a
• 40/78
• 400,000
• 500,000
• A/t
• Accel
• Assembly
• Brake
• Brake/clutch sw in
• Clutch pedal
• Coast
• Control sws input
• Cruise control
• Cruise control amplifier
• Dk orn
• Engine on transaxle)
• Feedback pot pos
• Feedback pot sig
• Fender apron)
• Front of engine)
• Fuse
• G110 (1.8l)
• G130 (1.9l)
• G200
• G207
• Ground
• Horn
• Horn relay
• Hot at all times
• Hot in start or run
• I/p
• Joint connector c213
• M/t
• Meter
• Near harness routing shield)
• Of cowl panel)
• Off
• Ohms
• On/off sw
• Panel
• Pedal
• Pedal support)
• Position sw
• Power input
• Resume
• Sensor (vss)
• Servo
• Set/
• Slipring
• Sol feed
• Stop
• Support)
• Sw assembly
• Tan
• Transmission)
• Under horn pad)
• Vac sol
• Vacuum sol control
• Vehicle speed
• Vent sol
• Vent sol control
• Vss ground
• Vss signal