CRUISE CONTROL – Nissan Armada SL 2011 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Armada SL 2011

List of elements for Cruise Control Wiring Diagram for Nissan Armada SL 2011:

• (armada: behind left side of dash) combination switch (spiral cable)
• (at right front of engine compt) e9
• (titan: behind left side of dash) a/t assembly
• 13p
• 15g m31
• 18g
• 19g
• 46g
• Accelerator pedal position (app) sensor (titan: at top of accelerator pedal assembly)
• Aps1
• Aps2
• Ascd brake switch (if equipped) (titan: on bracket, above brake pedal)
• Ascd steering switch
• Ascdsw
• Avcc
• Avcc2
• Bncsw
• Brake
• C1 (vin)
• C2 (vout)
• C3 (gnd) f506
• Can-h
• Can-l
• Cancel switch
• Close
• Combination meter
• Computer data lines system
• Cruise ind
• E152
• E16
• E9 (at right front of engine compt)
• Ecm (at right side of engine compt)
• Electric throttle control actuator (armada: at top left side of engine) (titan: at left front of engine compt)
• Exterior lights system
• F14
• F502
• F503
• F505
• F54
• Fuse 10a
• Fuse block (j/b) (behind right end of dash)
• Gnd
• Gnd-a
• Gnd-a2
• Hot at all times
• Hot in on or start
• Input speed sensor 1
• Input speed sensor 2
• M102
• M24
• M30
• M31
• M60
• M61 (behind center of dash)
• Motor 1
• Motor 2
• On/off (main) switch
• Open
• Out spd sen gnd
• Out spd sen vout
• Output speed sensor
• Pnk
• Red
• Resume/accel switch
• Rev sen vin
• Sensor 1
• Sensor 2
• Set ind
• Set/coast switch
• Stop lamp switch (titan: on bracket, above brake pedal)
• Tcm (transmission control module)
• Tps1
• Tps2
• Transmission range switch
• Unified meter control unit (w/ information display)