CRUISE CONTROL – Nissan Cube SL 2010 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Cube SL 2010

List of elements for Cruise Control Wiring Diagram for Nissan Cube SL 2010:

• (left side of dash) bcm (body control module)
• (top of steering column) combination switch (spiral cable)
• A/t
• Abs actuator & electric unit (left rear of engine room)
• Accel/res switch
• Accelerator pedal position sensor
• Aps1
• Aps2
• Ascd brake switch (if equipped) (left side of dash)
• Ascd clutch switch (if equipped) (left side of dash)
• Ascd steering switch (if equipped)
• Ascd sw
• Avcc-aps1
• Avcc-aps2
• Avcc-tps
• Bnc sw
• Brake
• Can-h
• Can-h gnda ascdsw
• Can-l
• Cancel switch
• Closed
• Coast/ set
• Combination meter
• Computer data lines system
• Cruise ind
• Cvt
• Cvt unit
• E15
• E16
• E19
• E21 (right of engine room)
• E38
• Ecm (left rear of engine room)
• Electric throttle control actuator
• Fuse 10a
• Fuse 64 15a
• Fuse block j/b (left side of dash)
• Gnd
• Gnda-aps1
• Gnda-aps2
• Gnda-tps
• Hot at all times
• Hot in on or start
• Ign sig
• Ipdm e/r (intelligent power distribution module engine room) (left side of engine room)
• M/t
• M302
• M33
• M71
• Main (on/off) switch
• Mot rly
• Motor 1
• Motor 2
• Open
• Pnk
• Primary speed sensor (front of engine room)
• Pwr sply
• Red
• Secondary speed sensor (rear of engine room)
• Sensor 1
• Sensor 2
• Set ind
• Stop lamp switch (left side of dash)
• Switch
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tps1
• Tps2
• Transmission control module (tcm) (cvt: left side of dash)
• Vdc gnd
• Vmot
• W/ intelligent key