CRUISE CONTROL – Nissan Juke S 2013 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Juke S 2013

List of elements for Cruise Control Wiring Diagram for Nissan Juke S 2013:

• Accelerator pedal position sensor (on accelerator pedal bracket assembly)
• Aps gnd
• Aps1
• Aps2
• Ascd steering sw
• Ascd steering switch
• B7 e107
• Bpp sw
• Brake pedal position switch (on brake pedal bracket)
• Can-h
• Can-l
• Cancel
• Close
• Clutch pedal position switch (top of clutch pedal assembly)
• Combination meter
• Combination switch (spiral cable) (in steering column)
• Computer data lines system
• Cpp sw
• Cruise ind
• E105
• E15
• E18
• E38
• Ecm (left side of engine compt)
• Electric throttle control actuator (on throttle body)
• Exterior lights system
• F26
• Fuse 10a
• Fuse 15a
• Fuse block j/b (left end of dash)
• Fuse, fusible link & relay box (on battery (+) post)
• Hot at all times
• Hot in on or start
• Ign sig
• Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
• M302
• M33
• M77
• Nca
• Open
• Pnk
• Pri spd sens
• Primary speed sensor (left side of transmission)
• Pwr sply
• Red
• Res/acc
• Sec spd sens
• Secondary speed sensor (top of transmission)
• Sens gnd
• Sensor 1
• Sensor 2
• Set ind
• Set/cst
• Shield
• Stop lamp switch (on brake pedal bracket)
• Stop lp sw
• Tan
• Tcm (left rear of engine compt)
• Throttle control motor
• Throttle control motor relay
• Throttle ctrl rly
• Throttle mtr pwr sply
• Throttle mtr(close)
• Throttle mtr(open)
• Throttle position sensor
• Tps1
• Tps2