CRUISE CONTROL – Nissan Murano S 2013 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Murano S 2013

List of elements for Cruise Control Wiring Diagram for Nissan Murano S 2013:

• (in steering column) combination switch (spiral cable)
• (left side of transmission) cvt unit
• (on transmission) tcm (transmission control module)
• Accelerator pedal position sensor (above accelerator pedal)
• Acsd steering switch
• Aps1
• Aps2
• Ascd brake switch (on brake pedal bracket)
• Ascd sw
• Brk sw
• Can-h
• Can-l
• Cancel
• Combination meter
• Computer data lines system
• Cruise ind & set ind
• E10
• E103
• E105
• E16
• E38 (left side of engine compt)
• Electric throttle control actuator (integral to throttle body)
• Engine control module (ecm) (left front of engine compt)
• Engine controls system
• F12
• Fuse 10a
• Fuse 43 10a
• Fuse 51 15a
• Fuse block (j/b) (left end of dash)
• Gnd
• Hot at all times
• Hot in on or start
• Ipdm e/r (intelligent power distribution module engine room) (in engine room relay box)
• M11
• M303
• M33
• Main (on/off)
• Motor close
• Motor open
• Motor relay
• Nca
• Pnk
• Pri sens
• Primary
• Pwr sply
• Red
• Resume/ accelerate
• Sec sens
• Secondary
• Sen gnd
• Sens gnd
• Sens pwr
• Sens pwr sply
• Sensor 1
• Sensor 2
• Set/ coast
• Speed sensor
• Speed sensor (on transmission)
• Stop light switch (on brake pedal bracket)
• Stop lp
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tps1
• Tps2