CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Quest SE 2009
List of elements for Cruise Control Wiring Diagram for Nissan Quest SE 2009:
- (right side of engine compt) e24
- 1q e30
- Accelerator pedal position sensor (behind left side of dash)
- Aps1
- Aps2
- Ascd brake switch (behind left side of dash)
- Ascd steering switch
- Ascd sw
- Avcc
- Avcc2
- Bnc sw
- Brake
- Can-h
- Can-l
- Cancel switch
- Close
- Combination meter
- Computer data lines system
- Cruise ind
- E16
- E24 (right side of engine compt)
- Ecm (right rear of engine compt)
- Electric throttle control actuator (left rear of engine compt)
- F54
- Fuse 10a
- Fuse 15a
- Fuse block (j/b) (behind left side of dash)
- Gnd
- Gnd-a
- Gnd-a2
- Hot at all times
- Hot in on or start
- M102
- M30
- M79 (behind right end of dash)
- Main switch
- Motor 1
- Motor 2
- Nca
- Open
- Pnk
- Red
- Resume/accel switch
- Sensor 1
- Sensor 2
- Set ind
- Set/coast switch
- Spiral cable (combination switch) (behind left side of dash)
- Stop lamp switch (behind left side of dash)
- Tps1
- Tps2
- Unified meter control unit