CRUISE CONTROL – Nissan Quest SV 2014 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Quest SV 2014

List of elements for Cruise Control Wiring Diagram for Nissan Quest SV 2014:

• Accelerator pedal position sensor (behind left side of dash)
• Acsd steering switch
• Aps1
• Aps2
• Ascd brake switch (behind left side of dash)
• Ascd brk sw
• Ascd str sw
• Can comm line
• Can-h
• Can-l
• Cancel
• Close
• Combination meter
• Combination switch (spiral cable)
• Computer data lines system
• Cruise ind
• Cvt unit
• E10
• E103
• E105
• E16
• E21 (rear of engine)
• E38 (rear of engine)
• Ecm (front left side of engine)
• Ecm pwr sply
• Electric throttle control actuator (right rear of engine compt)
• F12
• Fuse 10a
• Fuse 51 15a
• Fuse block (j/b) (behind left side of dash)
• Gnd
• Hot at all times
• Hot w/ ignition relay energized
• Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
• M11
• M303
• M33
• Main (on/off)
• Mtr (close)
• Mtr (open)
• Mtr pwr sply
• Mtr rly
• Nca
• Open
• Pnk
• Pri spd sens
• Primary speed sensor
• Red
• Resume/ accelerate
• Sec spd sens
• Secondary speed sensor
• Sens gnd
• Sens pwr
• Sens pwr sply
• Sensor 1
• Sensor 2
• Set/ coast
• Snsr gnd
• Snsr pwr
• Snsr pwr sply
• Stop lamp relay
• Stop lamp switch
• Stp lp sw
• Tcm (transmission control module) (left front of engine compt)
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tps1
• Tps2