CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Sentra LE 1994
List of elements for Cruise Control Wiring Diagram for Nissan Sentra LE 1994:
- (2dr)
- (4dr)
- (top of clutch
- 1995 vftc c
- 2.0l models only
- A/t
- A/t control unit (a/t only) (left kick
- Act. cntrl
- Actuator control
- Air valve solenoid
- Ascd cancel switch (top of brake
- Ascd clutch switch (m/t only)
- Ascd control unit (left side of i/p)
- Ascd hold relay (left side of i/p)
- Ascd main switch
- Ascd pump (left side of of safety wall)
- Ascd steering switch
- Ascd sw.
- Cancel
- Compartment)
- Console)
- Crs. cancl
- Cruise ind.
- Diode conn. (left side of i/p)
- Fuse & fusible link box (left front fender)
- Fuse d 10a
- Fuse e 15a
- Fuse t 10a
- Fuse y 10a
- G100 (left front fender)
- G101 (right front fender)
- G200 (left kick panel)
- Ground
- Horn relay (relay box, right front fender)
- Horn sw.
- Horn switch
- Horns system (horn)
- Hot at all times
- Hot in on or start fuse block (left side of i/p)
- Inhibitor relay (a/t only) (relay box, left front of engine
- Inhibitor switch (a/t only) (top of transmission)
- Instrument cluster
- Interior lights system
- M/t
- Nca
- Od cancel switch (below center
- Od cut
- Off
- Panel)
- Pedal support)
- Pnk
- Red
- Release valve solenoid
- Resume/ accelerate
- Set/coast
- Slip rings
- Smj conn. (left side of i/p)
- Speed
- Speed- ometer
- Spiral cable
- St lmp sw.
- Steering switch
- Stop lamp switch (top of brake pedal support)
- Vacuum motor
- Vehicle speed sensor (top of trans.)
- W/ airbag
- W/o airbag
- W/o tach
- W/tach