CRUISE CONTROL – Nissan Sentra S 2009 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Sentra S 2009

List of elements for Cruise Control Wiring Diagram for Nissan Sentra S 2009:

• (behind left end of dash)
• (in steering column) combination switch (spiral cable)
• (on brake pedal bracket) stop light switch
• Accel/res switch
• Accelerator pedal position sensor (on accelerator pedal bracket)
• Acsd steering switch
• Aps1
• Aps2
• Ascd brake switch (on brake pedal bracket)
• Ascd clutch switch (on clutch pedal bracket)
• Ascd sw
• Avcc-aps1
• Avcc-aps2
• Avcc-tps
• Bnc sw
• Brake
• Can-h
• Can-l
• Can-l gnda ascdsw
• Cancel switch
• Closed
• Coast/ set
• Combination meter
• Computer data lines system
• Cruise ind
• Cvt
• E16
• E39
• E43
• E46
• Ecm (on left side of firewall)
• Electric throttle control actuator (on throttle body)
• F23
• F24
• F25
• Fuse 10a
• Fuse 52 15a
• Fuse block j/b
• Gnd
• Gnda-aps1
• Gnda-aps2
• Gnda-tps
• Hot at all all times
• Hot at all times
• Hot in on or start
• Ign
• Ipdm e/r (intelligent power distribution module engine room) (left front of engine compt)
• M/t
• M30
• M57
• M78
• Motor 1
• Motor 2
• Motrly
• On/off (main) switch
• Open
• Pnk
• Pri sens
• Primary speed sensor (left side of transaxle)
• Red
• Sec sens
• Secondary speed sensor (top of transaxle)
• Sen gnd
• Sens
• Sens(gnd)
• Sensor 1
• Sensor 2
• Set ind
• Switch
• Throttle control motor relay
• Tps1
• Tps2
• Transmission control module (tcm) (left front of engine compartment)
• Unified meter control unit
• Vehicle speed sensor (w/o abs or cvt) (top right side of clutch housing)
• Vmot