CRUISE CONTROL – Nissan Xterra SE S/C 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Xterra SE S/C 2003

List of elements for Cruise Control Wiring Diagram for Nissan Xterra SE S/C 2003:

• (left kick panel) m14
• (not used)
• 4th cut sw
• A/t
• Ascd brake switch (on bracket, above brake pedal)
• Ascd clutch switch (on bracket, above clutch pedal)
• Ascd control unit (behind dash, left of steering column)
• Ascd motor actuator (at left front corner of engine compt)
• Ascd relay
• Ascd steering switch
• Brake nc sw
• Brake sw
• Cancel switch
• Clutch
• Clutch gnd
• Clutch pwr
• Coast/ set switch
• Combination meter
• Command sw
• Cruise
• Cruise lamp
• Cruise sw
• Fuse 11 10a
• Fuse 12 10a
• Fuse 22 15a
• Fuse 5 10a
• Fuse block (at left side of dash, behind cover)
• Ground
• Hot at all times
• Hot in on or start
• Ign
• M/t
• M14 (left kick panel)
• M38
• M39
• Motor
• Motor 1
• Motor 2
• Motor 3
• On/off switch
• Park/neutral position (pnp) switch (a/t) (on right side of transmission)
• Resume/ accel switch
• Set
• Set lamp
• Spiral cable
• Stoplight switch (on bracket, above brake pedal)
• Transmission control module (tcm) (a/t) (behind dash, left of steering column)
• Unified meter control unit (w/odo/ trip meter)
• Vehicle speed
• Vehicle speed sensor (on bottom left rear of transmission)