CRUISE CONTROL – Oldsmobile Silhouette 1995 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

3.8L

3.8L (VIN L), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1995

List of elements for 3.8L (VIN L), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1995:

• (below right side of i/p, behind convenience center)
• (engine compartment, mounted to left wheelhouse)
• (sps)
• 5 volt ref
• Brake switch assembly (mounted to brake pedal support)
• Brk in (vent&vac cntls)
• Btsi/tcc switch
• C 1995 vftc
• C11
• C12
• C14
• Closed
• Connected to throttle linkage
• Convenience center
• Cruise control release switch
• Cruise control servo
• Cruise control switch
• Cruise control vacuum release valve
• Cruise on input
• Engine controls system (3.8l vinl) & a/c compressor controls system
• F11
• F16
• Fuse block
• G120 (right side of engine, below electronic ignition module)
• Hot in run
• Hot in run, bulb test, or start
• Ign fuse 15a
• Nca
• Off
• Pnk
• Powertrain control module (pcm)
• R/a
• Resume/accel input
• Sensor return
• Servo posit sens (hi)
• Servo posit sens (lo)
• Servo position sensor
• Set switch
• Set/coast input
• Tan
• Throttle posit sens input
• Throttle position (tp) sensor (mounted to sequential fuel injection unit)
• Vac valve cntl
• Vacuum motor
• Vacuum release port
• Vacuum source
• Vacuum valve
• Variable a/c signal
• Vehicle speed sensor (mounted to top of transaxle)
• Vent
• Vent valve
• Vent valve cntl
• Vss input (hi)
• Vss input (lo)