CRUISE CONTROL – Pontiac Bonneville GXP 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Pontiac Bonneville GXP 2005

List of elements for Cruise Control Wiring Diagram for Pontiac Bonneville GXP 2005:

• 3.8l
• 4.6l
• All times
• Cancel input
• Cr cont fuse 10a
• Cruise control module (ccm) (on left side of engine compartment, on strut tower)
• Cruise control switch
• Cruise inhibit
• Cruise on/off
• Cruise set/coast
• Engage ouput
• Engaged input
• G106 (on left side of radiator support)
• Ground
• Head up display (hud) module (on top left side of dash)
• Hot at
• Hot in on or start
• Ign 1 fuse 10a
• Ignition
• Inhibit output
• Instrument panel cluster (ipc)
• Nca
• On/off
• Pnk
• Powertrain control module (pcm) (in air cleaner housing)
• Rear fuse block (under left rear seat)
• Resume/accel
• S201 (in i/p harness, 10 cm from hud display breakout)
• S215 (in body harness, 19.5 cm from p100)
• S216
• Set/coast
• Sp106 (on left strut tower)
• Sp304 (in body harness, 8.5 cm from g300 breakout)
• Stop lamp switch (lower left side of dash)
• Stop lamp/ at shift lock control switch (lower left side of dash)
• Stop lp fuse 15a
• Stp lp sig input
• Tcc/ cruise release switch
• Transmissions system
• Underhood fuse block (right front side of engine compartment)
• Vehicle spd sig
• Vehicle speed input
• Vehicle speed out
• Vehicle speed sensor (vss) (3.8l): on right front of transaxle, below power steering pump) (4.6l): lower right side of engine)
• Vss high
• Vss low
• W/ head up display