CRUISE CONTROL – Pontiac G3 Wave 2009 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Pontiac G3 Wave 2009

List of elements for Cruise Control Wiring Diagram for Pontiac G3 Wave 2009:

• 5v1
• 5v2
• 5v3
• 5v4
• Accelerator pedal position (app) sensor
• App sens 1 sig
• App sens 2 sig
• Brk sw sig
• Clutch pedal position (cpp) sensor (w/ 5 speed m/t)
• Computer data lines system
• Cruise ind
• Cruise pwr out
• Ems 1 fuse 6 15a
• Ems 2 fuse 5 10a
• Engine control module (ecm) (left front fender, near the battery)
• Exterior lights system
• G104 (next to starter)
• Gnd
• High speed data
• Hot at all times
• Hot in run or start
• I/p fuse block (left side of dash, in door opening)
• Ignition 1 volt
• Ignition switch
• Ind
• Inflatable restraint steering wheel module coil (under driver air bag module)
• Instrument panel cluster (ipc)
• J102
• J223 (i/p harness, near breakout to g201)
• Logic
• Low reference
• Low speed data
• Motor ctrl - 1
• Motor ctrl - 2
• Nca
• On sw sig cruise ctrl
• Pnk
• Position sens sig
• Red
• Resume + switch
• Right steering wheel control switch
• Run
• Sens 1 sig
• Sens 2 sig
• Set - switch
• Start
• Stop lamp fuse 7 15a
• Stop lamp switch (brake pedal assembly)
• Throttle body
• Transmission control module (tcm)
• Veh spd sens sig
• Vehicle speed sensor (vss) (a/t) (right rear of engine)
• Vehicle speed sensor (vss) (w/ 5 speed m/t) (right rear of engine)
• X2 underhood fuse block (left side of engine compt) x1