CRUISE CONTROL – Pontiac GTO 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Pontiac GTO 2005

List of elements for Cruise Control Wiring Diagram for Pontiac GTO 2005:

• (left rear of engine compt) powertrain interface module
• 5 volt ref
• 5 volt ref a
• 5 volt ref b
• A/t
• Accel sw sig
• Accelerator pedal position (app) sensor
• App sens 1 sig
• App sens sig
• C3 c
• Clutch pedal position (cpp) switch (manual transmission) (above clutch master cylinder)
• Computer data lines system
• Cpp sw sig
• Crctl active
• Crctl on
• Cruise control switch
• Cruise control, power mirrors & shiftlock control fuse 10a
• Cruise ctrl on sw sig
• Cruise ctrl rel sig
• D c3
• Engine control module (ecm)
• Engine sensors fuse 15a
• Extended travel brake sw sig
• G104 (front of engine, near right valve cover, attached to block)
• Ground
• High speed gmlan serial data bus (+)
• High speed gmlan serial data bus (-)
• Hot in run or start
• Instrument panel cluster (ipc)
• Instrument panel fuse block (below left end of dash)
• Low ref
• M/t
• On/off cancel
• Pnk
• Resm accel
• S111
• S128
• S208
• Serial data bus(+)
• Serial data bus(-)
• Set decel
• Set/coast sw sig
• Stop lamp switch (on top of brake pedal support)
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle actuator control (tac) motor
• Throttle body assembly
• Throttle position (tp) sensor
• Tp sens 2 sig
• Tp sens sig
• Transmission control module (tcm)
• Underhood fuse block (on right side of engine compt)
• Vehicle speed sensor (a/t: in transmission) (m/t: left rear of transmission)
• Vss high sig
• Vss low sig
• Vss sig