CRUISE CONTROL – Porsche 911 Carrera 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Porsche 911 Carrera 2008

List of elements for Cruise Control Wiring Diagram for Porsche 911 Carrera 2008:

• (behind accelerator pedal) pedal value sensor
• + bs
• +5v
• +5v pdl value sens 1
• +5v pdl value sens 2
• A/t
• A14
• A30
• A35
• A41
• A42
• Brake pedal switch
• Bridge plug (on relay support 1)
• Can comfort high
• Can comfort low
• Can display high
• Can display low
• Can drive high
• Can drive low
• Can high drive
• Can low drive
• Clutch interlock switch (at clutch pedal)
• Computer data lines system
• Dme control unit (left front of eng compt)
• Fuse f3 15a
• Fuse f4 10a
• Fuses holder b (on fuses support, behind left kick panel)
• Fuses holder c (on fuses support, behind left kick panel)
• Gp4 (center of support frame)
• Hot at all times
• M/t
• Pas (driver's recognition) control unit (under dash, left of steering column)
• Pdl value sens 1 gnd
• Pdl value sens 1 sig
• Pdl value sens 2 gnd
• Pdl value sens 2 sig
• Psm (porsche stability management) control unit (behind left side of dash)
• Rear control unit (under driver's seat)
• Release
• Sport chrono
• Steering column combined module
• Stop light sw
• Term 30
• Term 31
• Throttle valve (on throttle valve assembly)
• Throttle vlv gnd
• Throttle vlv mtr (+)
• Throttle vlv mtr (-)
• Throttle vlv sig
• Tiptronic control unit (behind right "b" pillar)
• Wake up