CRUISE CONTROL – Porsche Panamera Turbo 2011 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Porsche Panamera Turbo 2011

List of elements for Cruise Control Wiring Diagram for Porsche Panamera Turbo 2011:

• +5v
• +5v potentiometer
• A ntrl
• Acc control unit (center front of engine compt)
• Accelerator pedal position sensor
• Brake pedal switch
• Brake sig
• Can crash hi
• Can crash lo
• Can drive high
• Can drive low
• Can high 1
• Can low 1
• Clutch pedal sensor
• Clutch pedal switch low/start enable p/n
• Clutch switch
• Computer data lines system
• Dme control unit (right rear of engine compartment)
• Fuse 10a
• Fuse 20a
• Fuse 5a
• Gnd
• Gnd stop light sw
• Gp4 (right front engine compt)
• Gra
• Hot at all times
• Hot w/ main relay 1 energized
• Inter lk
• Left front fuse carrier
• Mb06 (right rear of engine compt)
• Mb08 (right rear of engine compt)
• Motor+
• Motor-
• Park/
• Pdk control unit (left side of dash)
• Pedal value sensor 1
• Pedal value sensor 1 +5v
• Pedal value sensor 1 ground potentiometer
• Pedal value sensor 2
• Pedal value sensor 2 ground potentiometer
• Pedal valve sensor 2 +5v potentiometer
• Potentiometer-
• Psm control unit (right side of engine compt)
• Red
• Right front fuse carrier
• Sens sig
• Sig 1
• Sig 2
• Steering column switching module
• Stop light
• Stop light switch
• Stop light switch (top of brake pedal assembly)
• Term 15
• Term 30tp
• Term 31
• Term 87
• Throttle valve
• Throttle valve +5v
• Throttle valve ground
• Throttle valve motor +
• Throttle valve motor -
• Throttle valve sensor 1
• Throttle valve sensor 2
• Ubatt bls
• X010
• X960