CRUISE CONTROL – Saab 9-7X 4.2i 2009 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Saab 9-7X 4.2i 2009

List of elements for Cruise Control Wiring Diagram for Saab 9-7X 4.2i 2009:

• (behind left of dash, near headlamp switch connector) jx205
• (i/p engine harness, 10 cm from breakout to x107) j105
• (or 2701)
• (or 451)
• (or nca)
• 5 volt ref
• Accelerator pedal position (app) sensor (above accelerator pedal, on bracket)
• App sensor 1
• App sensor 2
• B10
• Batt
• C9 x2
• Close
• Cruise ind
• Cruise release
• E3 x3
• Electronic brake control module (ebcm) (on inner left frame rail, beside transmission)
• Engine control module (ecm) (near lower left front of engine)
• Exterior lights system
• G108 (on lower left side of engine)
• Gnd
• Hot at all times
• Hot in on
• Hvac i fuse 40 10a
• Ign e fuse 22 10a
• Instrument panel cluster (ipc)
• Ipc class 2 serial
• J101 (except 4.2l)
• J239
• J272
• Logic
• Low ref
• Nca
• On sw
• On/off switch
• Open
• Pnk
• Rear fuse block (below left rear seat)
• Res/accel sw
• Res/accel switch
• Serial data
• Serial data bus +
• Serial data bus -
• Set/coast sw
• Set/coast switch
• Stop lamp fuse 12 25a
• Stop lamp sply volt
• Stop lamp switch (on brake pedal assembly)
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle body
• Tp sensor 1
• Tp sensor 2
• Transmission control module (tcm) (near lower left front of engine)
• Turn signal/ multi-function switch
• Underhood fuse block (on left side of engine compartment)
• Veh stop fuse 35 15a
• Vehicle speed sensor (vss) (on left rear of transfer case)
• Vss hi
• Vss lo