CRUISE CONTROL – Toyota Corolla VE 1998 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Toyota Corolla VE 1998

List of elements for Cruise Control Wiring Diagram for Toyota Corolla VE 1998:

• (3 a/t)
• (4 a/t)
• (m/t)
• A/t shift lever position switch (on left side of transaxle)
• A18
• B18
• B19
• C11
• C12
• C13
• C14
• Cancel
• Ccs
• Center j/b (behind center of dash)
• Cms
• Combination meter
• Cruise control actuator (on right rear of engine compt)
• Cruise control clutch switch (on bracket above clutch pedal)
• Cruise control ecu (behind right kick panel)
• Cruise control ind
• Cruise control switch (combination switch)
• D4 d4
• Data link connector 1 (on left rear of engine compt)
• Driver side j/b (behind left kick panel)
• Ect
• Ecu-ig fuse 10a
• Engine control module (below center of dash)
• G203
• G206 (right dash brace)
• G20o (left kick panel)
• Gauge fuse 10a
• Gnd
• Hot at all times
• Hot in on & start
• I11
• Idl
• Idl1
• Instrument panel j/b (behind left side of dash, at lower finish panel)
• Integration relay
• J/c 12 (behind lower center of dash, taped to harness)
• J/c 13 (behind upper right side of dash)
• J/c 14 (behind right kick panel)
• Junction connector j9, j10 (behind lower center of dash, taped to harness)
• Main
• Od1
• Resume/ accel
• Set/ coast
• Spd
• Speed- ometer
• Stop fuse 15a
• Stoplight switch (on bracket, above brake pedal)
• Stp-
• Vehicle speed sensor (on top of transaxle)