CRUISE CONTROL – Toyota RAV4 1996 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Toyota RAV4 1996

List of elements for Cruise Control Wiring Diagram for Toyota RAV4 1996:

• (a/t)
• (i/p harness, behind center of dash, below radio)
• (i/p harness, center of dash, above radio)
• (i/p harness, under right side of dash)
• (lower left side of dash) j/b 1
• (m/t)
• (right side, middle of engine compartment) data link connector 1
• (under center of dash)
• 2wd
• 4wd
• A8 b10
• Batt
• Cancel
• Ccs
• Cms
• Controls system (throttle position sensor)
• Cruise control actuator (rear left corner of engine compartment)
• Cruise control clutch switch (on bracket, above clutch pedal)
• Cruise control ecu (behind right side of dash)
• Cruise control ind
• Cruise control switch (combination switch)
• Dome fuse 15a
• Ect
• Ecu-ig fuse 7.5a
• Engine control module (engine & electronically controlled transmission ecu (a/t), engine ecu (m/t)) (below center of dash)
• Fuse block (lower left side of dash)
• G200 (left kick panel)
• G203 (right kick panel)
• Gauge fuse 10a
• Gnd
• Hot at all times
• Hot in on and acc
• I11
• I7 (i/p harness, behind right
• Idl
• Instrument cluster
• J/b 1 (lower left side of dash)
• J/c 10
• J/c 10,11 (under center of dash)
• J/c 7 (center of dash)
• Main
• Od1
• Park/neutral position switch (front of transaxle)
• Pnk
• Resume/ accel
• Set/ coast
• Side of dash)
• Spd
• Stop fuse 10a
• Stop light switch (under left side of dash, at brake pedal bracket)
• Stp-
• Transmissions system (electronically controlled transmission solenoid)
• Vehicle speed sensor (on transmission)
• Vr1
• Vr2
• Vr3
• Vss output