CRUISE CONTROL – Ford Expedition 1999 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Expedition 1999

List of elements for Cruise Control Wiring Diagram for Ford Expedition 1999:

• (not used)
• Accel
• Air bag sliding contact (top of steering column)
• Battery junc- tion box
• Brake pedal position (bpp) switch (under left side of dash)
• Brake press in
• Brake pressure switch (left rear corner of engine compt)
• C234
• C242
• C243
• C257
• Central junction box
• Coast
• Control sw gnd
• Control sw in
• Fuse 15a
• Fuse 20a
• Fuse 5a
• G105 (rear of right fender apron)
• G200 (lower left kick panel)
• G203 (lower right kick panel)
• Ground
• Harn, near breakout to instrument cluster)
• Horn relay (in battery junction box)
• Horn switches
• Hot at all times
• Hot in run
• Ign
• Interior lights system
• Nca
• Off
• Ohms
• Oss sensor
• Output shaft speed (oss) sensor (on left side of transmission)
• Powertrain control module (on right side of engine compartment)
• Remote anti-theft personality (rap) module (behind left side of dash)
• Resume
• S102
• S112
• S138 (engine sensor harn, right rear of engine compt)
• S143 (engine sensor harn, near breakout to windshield wiper motor)
• S202
• Set/
• Signal return
• Speed control servo (in left side of engine compt)
• Speed control switch assembly
• Steering column assembly
• Vehicle speed input
• Vehicle speed out