CRUISE CONTROL – Mitsubishi Raider DuroCross 2006 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Mitsubishi Raider DuroCross 2006

List of elements for Cruise Control Wiring Diagram for Mitsubishi Raider DuroCross 2006:

• (not used)
• 5 speed
• A919
• Accel/ resume
• Can c bus (+)
• Cancel
• Clockspring (in steering column)
• Coast
• Computer data lines system
• D65
• Dump
• Engine controls system
• F855
• Fuse 20a
• Fused b (+)
• G103 (at right front of engine compartment)
• Hot at all times
• Instrument cluster
• Integrated power module (at left side of engine compartment)
• K22
• K900
• Left speed control switch
• Nca
• On/ off
• Powertrain control module (at right side of engine compartment)
• Red
• Right speed control switch
• S/c sw 1 sig
• S/c vacuum solenoid ctrl
• S/c vent solenoid ctrl
• S118 (near rear of engine)
• S122 (near top of transmission)
• Sens gnd
• Sensor ground
• Set
• Speed control servo (at right front of engine compartment)
• Stop lamp switch (behind lower left side of dash)
• Throttle position sensor (on throttle body)
• Tp sens 1 sig
• Tp sensor 1 sig
• V32
• V35
• V36
• V37
• Vacuum
• Vent