CRUISE CONTROL
Cruise Control Wiring Diagram for Buick Enclave CXL 2008
List of elements for Cruise Control Wiring Diagram for Buick Enclave CXL 2008:
- (in steering column harness, near base of steering column) j293
- (in steering wheel harness, near sir coil) (w/ steering wheel control) j291
- (top of steering column, below steering wheel) inflatable restraint steering wheel module coil
- +5v
- 12-volt reference
- 5v ref
- Accelerator pedal position (app) sensor (above accelerator pedal)
- Air bag fuse 10a
- All times
- App sen 1 sig
- App sen 2 sig
- Automatic transmission
- Body control module (bcm) (under left side of dash)
- Brake pedal position sensor (top of brake pedal assembly)
- Cancel
- Computer data lines system
- Control solenoid valve assembly
- Cruise cntrl ind
- Cruise cntrl sw sig
- Cruise ind
- Cruise switch
- Driver information center (dic) display
- Ecm fuse 15a
- Engine control module (ecm) (left front corner of engine compt)
- G110 (right front of engine, mounted to cylinder head)
- G301 (behind left kick panel)
- Glman ser data bus+
- Glman ser data bus-
- Gmlan ser data bus+
- Gmlan ser data bus-
- Gmlan serial data
- Gnd
- Ground
- Hot at
- Hot w/ ign relay energized
- I/p fuse block (behind right end of dash) x2
- Ign
- Instrument panel cluster (ipc)
- J215
- Left steering wheel control switch assembly
- Logic
- Low ref
- Output speed sensor
- Pnk
- Reset+
- Sens sig
- Set-
- Sound systems
- Stop lamp sup volt
- Tac mot cntrl 1
- Tac mot cntrl 2
- Tan
- Throttle body (top rear of engine)
- Tp sen 1 sig
- Tp sen 2 sig
- Transmission control module
- Transmissions & sound systems
- Underhood fuse block (above right front wheelwell)