STARTING/CHARGING – Buick Regal GS 2000 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Buick Regal GS 2000

List of elements for Charging Wiring Diagram for Buick Regal GS 2000:

• (not used) a
• A8 c1
• B12
• Battery
• Charge ind
• Cluster fuse 10a
• Computer data lines
• F term monitor
• Fusible link (10 ga- rust)
• G101 (right side of engine compt, at base of battery)
• G129 (left of starter, on transaxle stud)
• Gen fuse 10a
• Generator l
• Hot at all times
• Hot in run, bulb test or start
• I/p fuse block (behind right side of dash, in right door opening)
• Instrument cluster
• L term monitor c2
• P b+
• Pnk
• Power distribution system
• Powertrain control module (pcm) (left side of engine compt, in air cleaner assembly)
• Red
• Ser. data class 2 c1
• Solid state
• Splice pack (s205) (below dash, right of steering column)
• Starter solenoid
• Underhood fuse block (mounted to right strut tower)

Starting Wiring Diagram for Buick Regal GS 2000

List of elements for Starting Wiring Diagram for Buick Regal GS 2000:

• (2000)
• (2001)
• (or red)
• 30a
• Acc
• B red
• Battery
• Bulb test
• Charging circuit (fusible link)
• Crank
• Crank maxifuse 40a
• Crank relay
• Crank signal bcm, cluster fuse 1oa
• G101 (right side of engine compartment, at base of battery)
• G129 (left of starter, on transaxle stud)
• Hold- in coil
• Hot at all times
• I/p fuse block (behind right side of dash, in right door opening)
• Ign main 1 fuse 40a
• Ignition switch
• Lock
• Nca
• Off
• Park neutral position (pnp) switch (on top right rear of transaxle)
• Pcm bcm u/h relay fuse 10a
• Pnk
• Powertrain control module (pcm) (left front side of engine compartment, in air cleaner assembly)
• Pull- in coil
• Red
• Remote battery stud
• Run
• S228
• S234
• Start
• Starter enable
• Starter motor
• Starter solenoid
• Underhood fuse block (mounted to right strut tower)