CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Frontier SL 2012
List of elements for Cruise Control Wiring Diagram for Nissan Frontier SL 2012:
- (on bracket, above brake pedal) stop light switch
- 1q e160
- 2.5l
- 4.0l
- 42g
- 43g
- A/t
- A/t assembly
- Accel/ res switch
- Accelerator pedal position (app) sensor (under left side of dash)
- Aps1
- Aps2
- Ascd brake switch (on bracket above brake pedal)
- Ascd clutch switch (on bracket, above clutch pedal)
- Ascd steering switch (if equipped)
- Ascd sw
- Avcc
- Avcc 2
- Avcc2
- Bncsw
- Brake
- C1 (vout)
- C2 (vin)
- C3 (gnd)
- Can-h
- Can-l
- Cancel switch
- Coast/ set switch
- Combination meter
- Combination switch (spiral cable)
- Computer data lines system
- Cruise ind
- E15 (right front of engine compt)
- E152
- E16
- E24 (4.0l) e15 (2.5l) (right front of engine compt)
- Electric throttle control actuator (on throttle body)
- Engine control module (ecm) (right rear of engine compt)
- F502
- F503
- F505
- F506
- F52
- F54
- Fuse 12 10a
- Fuse 14 10a
- Fuse 19 10a
- Fuse 20 10a
- Fuse block (j/b) (right end of dash)
- Gnd
- Gnd-a
- Gnd-a2
- Hot at all times
- Hot in on or start
- Input speed sensor
- Input speed sensor 2
- M/t
- M102
- M30
- M31
- M61 (behind right side of dash)
- Motor 1
- Motor 2
- Nca
- On/off main switch
- Out spd gnd
- Out spd vout
- Output speed sensor
- Pnk
- Red
- Rev sen vin
- Sensor 1
- Sensor 2
- Set ind
- Tcm (transmission control module)
- Throttle control motor
- Throttle position sensor
- Tps 1
- Transmission range switch
- Unified meter control unit (w/ information display)