CRUISE CONTROL – Nissan Titan PRO-4X 2013 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Titan PRO-4X 2013

List of elements for Cruise Control Wiring Diagram for Nissan Titan PRO-4X 2013:

• (behind left side of dash) a/t assembly
• (right rear of engine) j/c f01
• 36g
• 65g m31
• 68g
• 69g
• 9p m4
• Accelerator pedal position (app) sensor (at top of accelerator pedal assembly)
• Aps1
• Aps2
• Ascd steering switch (if equipped)
• Ascdsw
• Avcc
• Avcc2
• Bncsw
• Brake
• Brake pedal position switch (if equipped) (top of brake pedal assembly)
• C1 (vin)
• C2 (vout)
• C3 (gnd) f506
• Can-h
• Can-l
• Cancel switch
• Close
• Combination meter
• Combination switch (spiral cable)
• Computer data lines system
• E152
• E16
• E9 (at right front of engine compt)
• Ecm (at right side of engine compt)
• Electric throttle control actuator (at left front of engine compt)
• Exterior lights system
• F14
• F502
• F503
• F505
• F54
• Fuse 10a
• Fuse block (j/b) (behind right end of dash)
• Gnd
• Gnd-a
• Gnd-a2
• Hot at all times
• Hot in on or start
• Input speed sensor 1
• Input speed sensor 2
• M102
• M24
• M30
• M31
• M60
• Motor 1
• Motor 2
• On/off (main) switch
• Open
• Out spd sen gnd
• Out spd sen vout
• Out spd sens pwr
• Output speed sensor
• Pnk
• Red
• Resume/accel switch
• Sensor 1
• Sensor 2
• Set/coast switch
• Shift interlock system
• Stop lamp switch (on bracket, above brake pedal)
• Tcm (transmission control module)
• Tps1
• Tps2
• Transmission range switch
• Unified meter control unit
• W/ column shift
• W/ floor shift