Čeština
Dansk
Deutsch
Ελληνικά
English
Español
Suomi
Français
Français
עברית
Hrvatski
Magyar
Italiano
日本語
한국어
Nederlands
Polski
Português
Português
Română
Русский
Slovenčina
Slovenščina
Svenska
Türkçe
中文 (中国)
Dodge Intrepid ES 1998 - 1998 ELECTRICAL Fuses & Circuit Breakers - Concorde & Intrepid
Dodge Intrepid ES 1998 - IDENTIFICATION JUNCTION BLOCK
CAUTION: When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.
NOTE: The Junction Block (JB) may also be referred to as the fuse block.
The junction block is located behind the end cover at the left side of the instrument panel. See Fig. 1 .
Fig. 1: Dodge Intrepid ES 1998 - Component Locations - Locating Passenger Compartment Junction Block
Dodge Intrepid ES 1998 - Fuse Load Capacities
Fuse are color coded as well as marked for identification. Always replace a fuse with a fuse of the correct amperage rating. See FUSE COLOR CODE IDENTIFICATION .
Dodge Intrepid ES 1998 FUSE COLOR CODE IDENTIFICATION
Fuse Color 5-Amp Tan 10-Amp Red 15-Amp Light Blue 20-Amp Yellow 30-Amp Green
Dodge Intrepid ES 1998 - Fuse Replacement
- Before replacing a fuse, always turn off the electrical item concerned. To identify a blown fuse, see Fig. 2 . Turn the ignition key to the "LOCK" position.
- Open the fuse cover.
- Referring to the fuse load capacity table, check the fuse pertaining to the problem. See FUSE COLOR CODE IDENTIFICATION
- A fuse puller is in the fuse block inside the car. First, pull the fuse puller out of the fuse block. See Fig. 3 . Then, using the fuse puller, pull the fuse straight out from the fuse block. If the fuse is not blown, something else must be causing the problem.
- Insert a new fuse of the correct amperage rating securely into the clip.
Fig. 2: Dodge Intrepid ES 1998 - Component Locations - Identifying Blown Fuse
Fig. 3: Dodge Intrepid ES 1998 - Component Locations - Removing A Blown Fuse
Dodge Intrepid ES 1998 - Fuse & Circuit Breaker Identification
Open the cover at the left side of the instrument panel for access to the fuses. The fuse block contains blade-type fuses, relays, and circuit breakers for high-current circuits. For location and identification of fuse block fuses and relays. See Fig. 4 and Fig. 5 .
Dodge Intrepid ES 1998 - POWER DISTRIBUTION CENTER
NOTE:
The Power Distribution Center (PDC) is located in the engine compartment, next to battery. The PDC contains fuses and relays, a label which identifies these components is located on the underside of the cover. See Fig. 6 -Fig. 8 .
