Dodge Neon High Line 1999 - 1999 ELECTRICAL Fuses & Circuit Breakers - Neon

Dodge Neon High Line 1999 - IDENTIFICATION FUSE BLOCK

CAUTION:

When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.

To identify fuse block fuse applications, see FUSE BLOCK FUSE IDENTIFICATION table. The fuse block is located behind fuse access panel at the driver's side of the instrument panel. See Fig. 1 . To remove the panel, pull it out. To identify fuse block components, see Fig. 2 .

Dodge Neon High Line 1999 FUSE BLOCK FUSE IDENTIFICATION

Fuse (Amp)	Application
1 (15)	Cigar Lighter
2 (15)	Tail Light, License Plate Lamp, Sidemarker Light & Instrument Cluster Illumination Feed
3 (15)	Front Door Lock Switches
4 (10)	Fog Lights
5 (10)	Airbag Diagnostic Module, Ignition Run Only Feed
6 (10)	Turn Signal Switch
7 (25)	A/C Blower Motor & Heater Blower Motor
8 (10)	Heated Rear Window Switch, A/C Cycling Clutch Switch, Fan Relay, Back-Up Lights
9 (10)	Airbag Diagnostic Module & Ignition Run Only Feed
10 (15)	Transaxle Lock-Up Solenoid, Anti-Lock Brake Controller, Anti-Lock Brake Relay, Powertrain Control Module, Evap/Purge Solenoid & EGR Solenoid
11 (5)	Daytime Running Lights Module (Canada), Instrument Cluster Gauges, Warning Lights & Chime
12 (4)	Heated Rear Window, Fog Light Switch Illumination, Instrument Cluster, A/C Blower Switch, Radio, Transmission Range Light Indicator & Ash Receiver Light
13	Not Used
14	Not Used
15 (20)	Wipe/Wash Switch & Windshield Wiper Motor
16 (10)	Radio Accessory Feed
17 (10)	Left Headlight
18 (10)	Right Headlight
19	Not Used
20	Not Used

Fig. 1: Dodge Neon High Line 1999 - Component Locations - Locating Fuse Block

Fig. 2: Dodge Neon High Line 1999 - Component Locations - Identifying Fuse Block Components

Dodge Neon High Line 1999 - POWER DISTRIBUTION CENTER

To identify power distribution fuse applications, see POWER DISTRIBUTION CENTER FUSE IDENTIFICATION table. Power distribution center is located in the engine compartment, behind the battery. See Fig. 3 . A label identifying the components and circuits is located on the underside of the cover. To identify power distribution center components, see Fig. 4 .

Dodge Neon High Line 1999 POWER DISTRIBUTION CENTER FUSE IDENTIFICATION

Fuse (Amp)	Application
2 (40)	Ignition Switch
3 (40)	Fuse Block, Headlamp Switch
5 (30)	Solid State Fan Relay, Diode, Radiator Fan Motor
8 (30)	Rear Window Defogger Switch
10 (40)	Controller Anti-Lock Brake
11 (30)	Ignition Switch, Engine Starter Motor Relay In PDC
13 (10)	Underhood Lamp, Right/Left Visor Vanity Lamps, Map/Reading Lamps, Glove Box Lamp/Switch, Radio, Power Mirror Switch, Instrument Cluster, Trunk Lamp, Dome Lamp, Diode No. 2, Ignition Key Light Relay & Interior Lamp Relay
18 (20)	A/C Compressor Clutch Relay, Controller Anti-Lock Brake
20 (10)	Turn Signal/Hazard Switch
21 (20)	Fuel Pump Module, Fuel Pump Relay, Powertrain Control Module, Data Link Connector, Automatic Shut Down Relay, Oxygen Sensor, Generator, Fuel Injectors No. 1, 2, 3 & 4, Ignition Coil & Noise Suppressor
23 (15)	Horn Relay
25 (15)	Brake Lamp Switch

Fig. 3: Dodge Neon High Line 1999 - Component Locations - Locating Power Distribution Center

Fig. 4: Dodge Neon High Line 1999 - Component Locations - Identifying Power Distribution Center Components