ANTI-LOCK BRAKES – Infiniti I35 2002 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams, with Dynamic Stability Control (1 of 2) for Infiniti I35 2002

List of elements for Anti-lock Brake Wiring Diagrams, with Dynamic Stability Control (1 of 2) for Infiniti I35 2002:

• 11k
• Abs actuator (at left rear corner of engine compartment)
• Abs w/l
• B30 (left "b" pillar)
• Bls
• Brake fluid level switch (on master cylinder reservoir)
• Can-h
• Can-l
• Computer data line system
• Data link connector (lower left side of dash)
• Diag-k
• Diag-l
• E53 (front of right front fender)
• Exterior light system
• Fl mav
• Fl mv-av
• Fl mv-ev
• Fl ss
• Fl ss gnd
• Fl usv
• Fr mav
• Fr mv-av
• Fr mv-ev
• Fr ss
• Fr ss gnd
• Fr usv
• Fuse 2 15a
• Fuse 30 10a
• Fuse 31 10a
• Fuse block (behind left end of dash)
• Gnd
• Gnd1
• Gnd2
• Hot at all times
• Hot in on or start
• Inhibit-sw (n)
• Left front wheel sensor
• Left rear wheel sensor
• Lis
• Nca
• Park/ neutral position switch (on left rear side of transaxle)
• Pkb sw
• Pnk
• Pressure sensor
• Psm
• Pss
• Psu
• Red
• Right front wheel sensor
• Right rear wheel sensor
• Rl mv-av
• Rl mv-ev
• Rl ss
• Rl ss gnd
• Rr mv-av
• Rr mv-ev
• Rr ss
• Rr ss gnd
• Slip lamp
• Stop light switch (on brake pedal bracket)
• Vcc
• Vdc off lamp
• Vdc off sw
• Vdc/tcs/abs control unit (under driver's seat)
• Vout
• Yrsm
• Yrsref
• Yrss
• Yrst
• Yrsu

Anti-lock Brake Wiring Diagrams, with Dynamic Stability Control (2 of 2) for Infiniti I35 2002

List of elements for Anti-lock Brake Wiring Diagrams, with Dynamic Stability Control (2 of 2) for Infiniti I35 2002:

• (top left side of dash) m9
• 12v
• Abs ind
• Actuator relay
• Brake ind
• Can-h
• Can-l
• Combination meter
• Computer data line system
• Diode
• Fuse d 50a
• Fuse e 30a
• Fuse, fusible link box relay block (at left side of engine compt)
• Ground
• Hot at all times
• M25 (left side of dash)
• Motor relay
• Nca
• Parking brake switch (at base of parking brake lever)
• Pnk
• Red
• Slip ind
• Steering angle sensor (on steering column)
• Tcs ind
• Vdc off switch (under left side of dash)
• Vdc relay box (at left rear of engine compartment)
• Yaw rate/ side g sensor (under center console)

Anti-lock Brake Wiring Diagrams, without Dynamic Stability Control for Infiniti I35 2002

List of elements for Anti-lock Brake Wiring Diagrams, without Dynamic Stability Control for Infiniti I35 2002:

• 11k
• Abs ind
• Abs sila
• Abs/tcs control unit (under driver's seat)
• Actuator
• Bls
• Can-h
• Can-l
• Combination meter
• Control unit
• Data link computer system
• Data link connector (lower dash of dash)
• Diag-k
• Diag-l
• E11 (front of left front fender)
• Fl in
• Fl out
• Fl ss
• Fl ss gnd
• Fr in
• Fr out
• Fr ss
• Fr ss gnd
• Fuse & fusible link box (at left side of engine compartment)
• Fuse 2 15a
• Fuse 30 10a
• Fuse 31 10a
• Fuse block (behind left side of dash)
• Fuse d 40a
• Fuse e 40a
• Hot at all times
• Hot in on or start
• Ign
• Interior lights system
• Left front wheel sensor
• Left rear wheel sensor
• M25 (left side of dash)
• M9 (top left side of dash)
• Meter out
• Motor mon
• Motor relay
• Red
• Relay act
• Relay mon
• Relay unit
• Right front wheel sensor
• Right rear wheel sensor
• Rl in
• Rl out
• Rl ss
• Rl ss gnd
• Rr in
• Rr out
• Rr ss
• Rr ss gnd
• Slip ind
• Slip sila
• Solenoid valve relay
• Stoplight switch (on brake pedal bracket)
• Tcs ind
• Tcs off sila
• Tcs on/off switch
• Tsc sw
• Unified meter control unit