CRUISE CONTROL – Lincoln Navigator 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Lincoln Navigator 2005

List of elements for Cruise Control Wiring Diagram for Lincoln Navigator 2005:

• (in engine control sensor harness, near breakout to left kick panel)
• (near breakout to rear of exhaust system) s141
• (on brake pedal support) deactivator switch
• Abs control module (at left side of engine compartment)
• Accelerator pedal position sensor (above accelerator pedal)
• Air bag sliding contact (under steering column)
• Bpp sw
• Brake pedal position switch (on brake pedal support)
• C175b
• C175e
• C175t
• C218b
• C270b
• C270e
• Central junction box (cjb) (behind right kick panel)
• Computer data lines system
• Electronic throttle control (etc) motor (top left of engine)
• Etc motor +
• Etc motor -
• Expedition (except eddie bauer & limited)
• Expedition eddie bauer, limited & navigator
• Fuse 7.5a
• Horns system
• Hot at all times
• Hs can +
• Hs can -
• Illumination
• Interior lights system
• Nca
• Off
• Oss sensor sig
• Output shaft speed (oss) sensor (expedition) (on rear of transmission)
• Powertrain control module (pcm) (on right side of firewall)
• Ref vol
• Resume
• S133
• S148
• S150 (in engine control sensor harness, near breakout to left rear of engine compt)
• S277
• Sensor 1 sig
• Sensor 2 sig
• Sensor 3 sig
• Set (+)
• Set (-)
• Sig 1
• Sig 2
• Sig rtn
• Steering wheel radio switch
• Steering wheel/speed control switch
• Sw sig
• Tan
• Throttle position sensor (tps) (on throttle body)
• Vref