ANTI-LOCK BRAKES
2.2L VIN F
2.2L VIN F, Anti-lock Brakes Wiring Diagram for Saturn L200 2003
List of elements for 2.2L VIN F, Anti-lock Brakes Wiring Diagram for Saturn L200 2003:
- (shorting bar between pin 20 & 21)
- 2x tach
- A10
- A11
- Abs 1 fuse 30a
- Abs 2 fuse 30a
- Abs indicator
- Abs tt
- B10
- Bcm/ecm/ cruise/abs fuse 10a
- Body control module (bcm) (behind upper right side of i/p)
- Brake fuse 15a
- Brake pressure modulator valve (bpmv)
- Brake sw in
- C3 e3
- C4 b4
- Computer data lines system
- D11
- D8 c4
- Data link connector (dlc) (lower left of i/p, near steering column)
- Delivered torque in
- E10
- E12
- Electronic brake control module (ebcm) (left side of eng compt, near strut tower)
- Exterior lights system
- F10
- G118 (front of eng block, above starter)
- G304 (left side of eng compt, near left strut tower)
- Ground
- Hot at all times
- Hot in on or start
- Hot in run
- Ign 1
- Ign 1 fuse 10a
- Ign 3 fuse 10a
- Instrument cluster
- Led ctrl
- Left front wheel speed sensor
- Left i/p fuse block
- Left instrument panel fuse block (lipfb)
- Left rear wheel speed sensor
- Lf speed sens
- Low trac tt
- Lr speed sens
- Nca
- Pnk
- Powertrain control module (pcm) (right rear of eng compt, on strut tower)
- Pwr out
- Red
- Redundant ground
- Request torque
- Requested torque
- Rf spd sens
- Rf speed sens
- Rf speed sens out
- Right front wheel speed sensor
- Right heated seat traction switch
- Right rear wheel speed sensor
- Rr speed sens
- S126
- Serial data
- Stop lamp switch (on brake pedal bracket)
- Tan
- Torque delivered
- Trac ctrl tt
- Traction active indicator
- Traction control sw
- Traction off indicator
- Underhood fuse block (uhfb)