A1 | Second battery |
E153 | Control and display unit for camping equipment, near front interior light |
G18 | Temperature sensor, on right C-pillar |
J65 | Heater control unit B3LP/D3LP, in intakt duct |
T2l | 2-pin connector, behind relay plate |
T4y | 4-pin connector, behind lower right B pillar trim |
T4z | 4-pin connector, behind relay plate |
T6f | 6-pin connector, behind upper left A pillar trim |
T12a | 12-pin connector |
T12e | 12-pin connector, in intake duct |
T26 | 26-pin connector |
TV8 | Terminal 58b junction box, grey |
57 | Earth point, lower part of left B-pillar |
* | Wire for diagnostic signal |
A1 | Second battery |
G40 | Hall sender |
J65 | Heater control unit B3LP/D3LP, in intakt duct |
J372 | Printed circuit board for temperature sensor, blower motor control unit and glow plug frequency |
Q6 | Glow plug, in heater |
S1 | Fuse in fuse box/ left C-pillar (operating unit fuse) |
S2 | Fuse in fuse box/ left C-pillar (operating unit fuse) |
S4 | Fuse in fuse box/ left C-pillar (heater unit fuse) |
T1 | Single connector |
T4 | 4-pin connector |
T4a | 4-pin connector |
T12 | 12-pin connector |
T12a | 12-pin connector |
T12e | 12-pin connector, in intake duct |
V81 | Combustion, fresh and hot air blower |
57 | Earth point, rear pillar, left |
253 | Earth connection, in heater unit wiring harness |
L59 | Connection (30), in heater unit wiring harness |