ELECTRONIC POWER STEERING – Chevrolet Pickup K1500 1998 – SYSTEM WIRING DIAGRAMS

ELECTRONIC POWER STEERING

Electronic Power Steering Wiring Diagram for Chevrolet Pickup K1500 1998

List of elements for Electronic Power Steering Wiring Diagram for Chevrolet Pickup K1500 1998:

• (diesel: i/p harness, approximately 8 cm from instrument cluster breakout, toward radio connectors breakout) (gasoline: i/p harness, approximately 12 cm from instrument cluster breakout toward radio connectors breakout)
• (front top of engine) g134
• (i/p harness, approximately 40 cm from instrument cluster breakout)
• (i/p harness, approximately 5 cm from dlc breakout)
• (right top of cylinder head) g120
• 5 volt ref
• Battery
• Dash fuse block (under left side of dash)
• Data
• Data link connector (dlc) (under left side of dash, left of steering column)
• Diesel
• Electronic variable orifice (evo)/passlock control module (under center of dash)
• Evo feed
• Evo solenoid out
• Gas
• Gauges fuse 4 10a
• Ground
• Hot at all times
• Hot in run or start
• Ignition
• Pnk
• S213
• S215
• S221
• S280
• Security/strg fuse 21 20a
• Sensor return
• Steering assist control solenoid (part of power steering pump)
• Steering handwheel speed sensor (on steering column, near firewall)
• Steering wheel posit signal
• Sws posit sig
• Vehicle control module (on left side of engine compartment)
• Vehicle speed sensor buffer (behind right side of dash)
• Volt ref
• Vss sig out
• Vss signal input