AUTOMOTIVE ELECTRICIANS PORTAL

ELECTRONIC SUSPENSION – Buick LeSabre Limited 1994 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Computer Command Ride for Buick LeSabre Limited 1994

Computer Command Ride for Buick LeSabre Limited 1994 https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html Automotive Electricians Portal FZCO Automotive Electricians Portal FZCO
Download PDF file

List of elements for Computer Command Ride for Buick LeSabre Limited 1994:

  • 2.8k ohm
  • 220 ohm
  • 330 ohm
  • Computer command ride (ccr) controller (below left front seat)
  • D13
  • Data link connector (below left i/p, next to i/p fuse block)
  • Diagnostic test in
  • E10
  • E11
  • E12
  • E13
  • E14
  • E15
  • E16
  • F10
  • F11
  • F12
  • F13
  • F14
  • F15
  • F16
  • Fault indicator test out
  • Fuse 5b 10a
  • G119 (above a/c compressor)
  • G200 (left kick panel)
  • Ground
  • Hot in run
  • I/p fuse block
  • Ign input
  • Lateral accel sw in
  • Lateral acceleration switch (below left front seat)
  • Left front strut
  • Left rear strut
  • Lf motor drive
  • Lf position in
  • Lr motor drive
  • Lr position in
  • Nca
  • Powertrain control module (behind right i/p, behind relay center, against bulkhead)
  • Red
  • Rf motor drive
  • Rf position in
  • Right front strut
  • Right rear strut
  • Rr motor drive
  • Rr position in
  • Vehicle speed input
  • Vehicle speed output
  • Wot input
  • Wot output

Electronic Level Control for Buick LeSabre Limited 1994

Electronic Level Control for Buick LeSabre Limited 1994 https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html Automotive Electricians Portal FZCO Automotive Electricians Portal FZCO
Get access to all wiring diagrams of the carDownload PDF file

List of elements for Electronic Level Control for Buick LeSabre Limited 1994:

  • to struts
  • * pressure passes through: -air dryer (maintains pressure in strut at 48-97 kpa, 7-14 psi) -pressure limiter valve limits maximum pressure in struts to 447-510 kpa, 64-74 psi)
  • A-closes with vehicle too high. b-closes 17-27 seconds after change in vehicle height. remains closed approximately 7 minutes maximum. c-closes when
  • Compressor motor
  • Elc compressor assembly (left side of engine compartment beside wheelhouse)
  • Elc relay (position e)
  • Enable and vehicle is too low.
  • Exhaust solenoid
  • From actu- ator arm
  • Fuse 5b 10a
  • Fuse 9b 20a
  • G100 (above left horn)
  • G200 (left kick panel)
  • Hot at all times
  • Hot in run
  • I/p fuse block
  • Level
  • Nca
  • Nca elc height sensor c (above right rear lower suspension compressor arm)
  • Power
  • Relay center (below i/p, left of steering column)
  • Reset
  • Signal
  • Solid state
  • Too high
  • Too low
  • Vent