ELECTRONIC SUSPENSION – Chevrolet Suburban C2500 2000 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for Chevrolet Suburban C2500 2000

List of elements for Electronic Suspension Wiring Diagram for Chevrolet Suburban C2500 2000:

• (on power steering pump fitting) electronic variable orifice solenoid
• 5 volt ref
• 5v reference
• A10
• A11
• A12
• B10
• B11
• B12
• Battery voltage
• Body wiring harness junction block (under left side of dash, near kick panel)
• Compressor motor
• Compressor motor relay (below engine wiring harness junction block)
• Compressor/ leveling module (on right rear frame rail)
• Computer data lines (dlc)
• Data lines
• Engine wiring harness junction block (left side of engine compt, near battery)
• Evo control
• Exhaust sol
• Fuse block (lower left side of dash)
• G998
• Ground
• Hot at all times
• Hot in run
• I/p wiring harness junction block (lower right side of dash)
• Ign 3 fuse 10a
• Left front position sensor (on left front suspension support)
• Left front shock solenoid valve
• Left rear position sensor (on left rear suspension support)
• Left rear shock solenoid valve
• Lift/dive signal
• Low reference
• Not used
• Position track 1
• Position track 2
• Powertrain control module (pcm) (behind right side of dash)
• Pressure sensor
• Red
• Ref voltage
• Relay control
• Right front position sensor (on right front suspension support)
• Right front shock solenoid valve
• Right rear position sensor (on right rear suspension support)
• Right rear shock solenoid valve
• Rtd module fuse 30a
• S112
• Sensor signal
• Solenoid control
• Solenoid ground
• Splice pack 410 (rear corner of right rear window)
• Steering handwheel/speed position sensor
• Stud 1 fuse 40a
• Suspension control module (rear of right rear wheelwell)
• Tan
• Vss input