ELECTRONIC SUSPENSION – Chevrolet Venture LT 1999 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram, with Inflator for Chevrolet Venture LT 1999

List of elements for Electronic Suspension Wiring Diagram, with Inflator for Chevrolet Venture LT 1999:

• (lower left "d" pillar) g999
• (under left rear of vehicle, behind wheelhouse)
• Air compressor exhaust solenoid
• Air compressor motor
• Auto level control air compressor relay
• Auto level control air inflator solenoid valve (in left rear of vehicle, behind wheelhouse)
• Auto level control inflator relay (in left rear of vehicle, behind wheelhouse)
• Auto level control sensor (mounted to rear cross- member above rear axle)
• Compressor signal
• Elc fuse 20a
• Exhaust signal
• Fuse block (right side of dash)
• G999 (lower left "d" pillar)
• Gnd
• Ground
• Hot at all times
• Hot in acc or run
• Inflator air switch (behind left rear wheelhouse)
• Mall/radio/ dic fuse 10a
• Nca
• Off
• Power input
• Reset
• Reset
• Resets after 10 minutes
• S441
• S443 (auto level control harn, under left rear wheelhouse)
• S445
• S465
• Solid state

Electronic Suspension Wiring Diagram, without Inflator for Chevrolet Venture LT 1999

List of elements for Electronic Suspension Wiring Diagram, without Inflator for Chevrolet Venture LT 1999:

• (under left rear of vehicle, behind wheelhouse)
• Air compressor exhaust solenoid
• Air compressor motor
• Auto level control air compressor relay
• Auto level control sensor (mounted to rear crossmember, above rear axle)
• Compressor signal
• Elc fuse 20a
• Exhaust signal
• Fuse block (right side of dash)
• G999 (lower left "d" pillar)
• Ground
• Hot at all times
• Hot in run, bulb test or start
• Ign 1 fuse 10a
• Nca
• Pnk
• Power input
• Reset
• S401
• S441
• S445