ELECTRONIC SUSPENSION – GMC Yukon Denali 2001 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for GMC Yukon Denali 2001

List of elements for Electronic Suspension Wiring Diagram for GMC Yukon Denali 2001:

• 5 volt ref
• A10
• A11
• A12
• B10
• B11
• B12
• Battery voltage
• Compressor motor
• Compressor/ leveling module
• Compressor/ leveling relay (rtd) (below engine wiring harness junction block)
• Computer data lines system
• Data lines
• Electronic variable orifice (evo) solenoid (on power steering pump fluid fittings)
• Engine wiring harness junction block (at left side of engine compt, near battery)
• Evo control
• Exhaust sol
• Fuse block (on lower left side of dash)
• G998
• Ground
• Hot at all times
• Hot in run
• I/p wiring harness junction block
• I/p wiring harness junction block (on lower right side of dash)
• Ign 3 fuse 10a
• Ignition 3
• Left front shock absorber solenoid
• Left front suspension position sensor (on left front suspension support)
• Left rear shock absorber solenoid
• Left rear suspension position sensor (on left rear suspension support)
• Lf damp servo
• Lf strut pos
• Lift/dive signal
• Low ref
• Low reference
• Lr damp servo
• Lr strut pos
• Nca
• Powertrain control module (pcm) (on left front of engine compt)
• Pressure sensor
• Red
• Relay control
• Rf damp servo
• Rf strut pos
• Right front shock absorber solenoid
• Right front suspension position sensor (on right front suspension support)
• Right rear shock absorber solenoid
• Right rear suspension position sensor (on right rear suspension support)
• Rr damp servo
• Rr strut pos
• Rtd module fuse 30a
• S112
• Sensor signal
• Solenoid control
• Splice pack sp410 (rear corner of right rear window)
• Steering wheel speed/ position sensor
• Str whl pos sig
• Stud 1 fuse 40a
• Suspension control module (rtd) (rear of right rear wheelwell)
• Tan
• Vss input