ELECTRONIC SUSPENSION – Oldsmobile Bravada 2002 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for Oldsmobile Bravada 2002

List of elements for Electronic Suspension Wiring Diagram for Oldsmobile Bravada 2002:

• 4wd fuse 15a
• Air suspension compressor assembly (except xl: behind right rear wheelwell, xl : on left rear frame rail)
• Air suspension inflator switch (xl: on left side of cargo area, except xl: (on right side of cargo area)
• B11
• Battery
• Control
• Ecas fuse 30a
• G305 (on left frame rail)
• Ground
• Hot at all times
• Hot in run
• Ign 3
• Instrument panel cluster
• Led signal
• Left rear air suspension sensor (on frame rail, near left rear suspension arm)
• On/off
• Powertrain control module (on upper left side of engine)
• Rear fuse block (below left rear seat)
• Red
• Right rear air suspension sensor (on frame rail, near right rear suspension arm)
• S117 (dash harness, 8.5 cm (3 in) from engine harness to dash harness connector breakout, toward the breakout for the underhood fuse block)
• S306
• Sensor ret
• Sensor sig
• Speed sens
• Tan
• Transmissions system
• Underhood fuse block (on left side of engine compt)