ELECTRONIC SUSPENSION – Pontiac Montana 2002 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram, with Inflator for Pontiac Montana 2002

List of elements for Electronic Suspension Wiring Diagram, with Inflator for Pontiac Montana 2002:

• (lower left "d" pillar) g401
• (not used)
• Air compressor exhaust solenoid
• Air compressor motor
• Air inflator switch (behind left rear wheelwell)
• Auto level control (alc) air compressor (under left rear of vehicle, behind wheelwell)
• Auto level control (alc) air inflator relay (in left rear of vehicle, behind wheelwell)
• Auto level control (alc) air inflator solenoid (in left rear of vehicle, behind wheelwell)
• Auto level control (alc) sensor (mounted to rear cross- member, above rear axle)
• Auto level control air compressor relay
• Compressor signal
• Elc/trailer fuse 25a
• Exhaust signal
• G401 (lower left "d" pillar)
• Gnd
• Hot at all times
• Hot w/ rap relay energized
• I/p fuse block (right side of dash)
• Nca
• Off
• Power
• Pwr qtr vent fuse 10a
• Reset
• Resets after 10 minutes
• S441
• S443 (alc harn, behind left rear wheelwell)
• Solid state

Electronic Suspension Wiring Diagram, without Inflator for Pontiac Montana 2002

List of elements for Electronic Suspension Wiring Diagram, without Inflator for Pontiac Montana 2002:

• (not used)
• Air compressor exhaust solenoid
• Air compressor motor
• Auto level control (alc) air compressor (under left rear of vehicle, behind wheelwell)
• Auto level control (alc) sensor (above rear axle)
• Auto level control air compressor relay
• Compressor signal
• Elc/trailer fuse 25a
• Exhaust signal
• G401 (lower left "d" pillar)
• Ground
• Hot at all times
• Hot w/ rap relay energized
• I/p fuse block (right side of dash)
• Nca
• Power input
• Pwr qtr vent fuse 10a
• Reset