Электросхемы СИСТЕМА КРУИЗКОНТРОЛЯ Hummer H3 Alpha 2008

СИСТЕМА КРУИЗКОНТРОЛЯ

Электросхема системы круизконтроля для Hummer H3 Alpha 2008

Электросхема системы круизконтроля для Hummer H3 Alpha 2008 - Список элементов:

• 5 volt reference 2
• 5-volt reference 1
• 5-volt reference 2
• A/t
• Accelerator pedal position (app) sensor (on accelerator pedal bracket)
• App sensor 1 signal
• App sensor 2 signal
• Class 2 serial data
• Clstr fuse 19 10a
• Computer data lines system
• Cruise control on/off switch
• Cruise control release signal
• Cruise control release switch (top of brake pedal assembly)
• Cruise control switch
• Cruise indicator
• Cruise/misc fuse 35 10a
• Engine control module (ecm) (right rear of engine compartment)
• G300 (under driver seat carpet, on floor board)
• Gmlan hi (+)
• Gmlan hi (-)
• Gnd
• Hot at all times
• Hot w/ run/ crank relay energized
• Instrument panel cluster (ipc)
• J215 (in body harness, approximately 14 cm (5.5 in) to right of stop lamp switch breakout in main harness)
• J251
• Logic
• Low reference
• M/t
• Off
• On/
• Pnk
• Power distribution system
• Res+
• Set-
• Stop fuse 54 15a
• Stop lamp control
• Stop lamp switch (above brake pedal assembly)
• Tac motor control-1
• Tac motor control-2
• Tan
• Throttle body (top of engine, mounted on upper air intake manifold)
• Tp sensor 1 signal
• Tp sensor 2 signal
• Transmission control module (tcm)
• Turn signal/multi-function switch
• Underhood fuse block (above left front wheelwell)
• Vehicle speed sensor (vss) (left rear of transfer case)
• Vss high signal
• Vss low signal