CRUISE CONTROL – Hummer H3 2007 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Hummer H3 2007

List of elements for Cruise Control Wiring Diagram for Hummer H3 2007:

• 5 volt reference
• Accelerator pedal position (app) sensor (on accelerator pedal bracket)
• App sensor 1 signal
• App sensor 2 signal
• Class 2 serial data
• Cluster fuse 19 10a
• Clutch release switch (at top of clutch pedal assembly)
• Coast
• Computer data lines system
• Cpp switch signal
• Cruise control on/off switch
• Cruise control switch signal
• Cruise indicator
• Cruise/misc fuse 35 10a
• G105 (on left inner front wheel well, behind battery)
• Hot at all times
• Hot in run or start
• Ignition
• Instrument panel cluster (ipc)
• Logic
• Low reference
• M/t
• Off
• On/
• Pnk
• Power distribution system
• Powertrain control module (pcm) (at left front side of engine compt)
• Resume/ accel
• Run/crank relay
• S215 (in body harness, approximately 14 cm (5.5 in) to right of stop lamp switch breakout in main harness)
• Set/
• Stop fuse 54 15a
• Stop lamp switch (above brake pedal assembly)
• Tac motor control-1
• Tac motor control-2
• Tan
• Tcc brake switch/cruise control release signal
• Tcc brake/cruise release switch (top of brake pedal assembly)
• Throttle actuator control (tac) motor
• Throttle body (top of engine, mounted on upper air intake manifold)
• Throttle position (tp) sens 1
• Throttle position (tp) sens 2
• Tp sensor 1 signal
• Tp sensor 2 signal
• Turn signal/multifunction switch
• Underhood fuse block (above left front wheel well)
• Vehicle speed sensor (vss) (left rear of transfer case)
• Vss high signal
• Vss low signal