STARTING/CHARGING – Hummer H2 2009 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Hummer H2 2009

List of elements for Charging Wiring Diagram for Hummer H2 2009:

• 200a
• 5v ref
• Aux hvac ign fuse 41 10a
• Battery
• Battery cable junction block (part of positive battery cable assembly)
• Body control module (bcm) (lower left of dash)
• Bus+
• Bus-
• Charge ind
• Chg ind
• Computer data lines system
• Driver information center (dic)
• Engine control module (ecm) (battery & underhood fuse block)
• G100 (on left front frame body mount)
• G102 (left front side of engine block)
• G103 (on front of right cylinder head)
• Gen sig
• Generator
• Generator inline fuse
• Gmlan
• Gnd
• Hot at all times
• Hot w/ run/ crnk relay energized
• Instrument panel cluster (ipc)
• Ipc fuse 10a
• Lo ref
• Logic
• Low ref
• Pnk
• Power distribution system
• Red
• Sens sig
• Starter
• Tan
• Underhood fuse block (left of engine compt)
• Volt

Starting Wiring Diagram for Hummer H2 2009

List of elements for Starting Wiring Diagram for Hummer H2 2009:

• 5-volt reference
• Acc
• Automatic transmission
• Automatic transmission internal mode switch (ims)
• Battery
• Battery cable junction block (part of positive battery cable assembly)
• Body control module (bcm) (lower left of dash)
• Computer data lines system
• Control solenoid valve assembly
• Crnk relay
• Data bus+
• Data bus-
• Engine control module (ecm) (battery & underhood fuse block)
• G100 (on left front frame body mount)
• G102 (left front side of engine block)
• G103 (on front of right cylinder head)
• G104 (at rear of left cylinder head)
• Ignition iii voltage
• Ignition switch
• J102
• J103
• Off
• Park/ neutral signal
• Red
• Run
• Start
• Starter
• Starter enable relay ctrl
• Strtr fuse 54 40a
• Tan
• Transmission control module (tcm)
• Underhood fuse block (left of engine compt)
• X2 f1