STARTING/CHARGING – Hyundai Scoupe 1992 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Hyundai Scoupe 1992

List of elements for Charging Wiring Diagram for Hyundai Scoupe 1992:

• (not used)
• Alternator
• Battery
• Canadian vehicles only
• Charge warning light
• Daytime running lights unit
• Electronic time & alarm control module (below right front seat)
• Engine compt relay box
• Engine running input
• Fuse 13 10a
• Fuse box
• Fusible link a 50a red
• G100 (left front side of engine compartment)
• G130 (left side of engine, on top of transmission)
• Hot in on or start
• Instrument cluster
• M55
• Main fusible link box
• Nca
• Passenger compartment relay box
• Pre- excitation resistor (left rear of engine compartment, on front of dash panel)
• Starting system

Starting Wiring Diagram for Hyundai Scoupe 1992

List of elements for Starting Wiring Diagram for Hyundai Scoupe 1992:

• A/t
• Battery
• Daytime running light unit (canada only)
• Ecu control relay
• Electronic control unit
• Engine compartment relay box
• Fusible link c 30a pnk
• G100 (left front corner of engine compartment)
• G130 (left side of engine, on top of transmission)
• G202
• Ground splice connector (left side of dash)
• Hold-in coil
• Ignition switch
• Lock acc
• M/t
• N d
• Nca
• Passenger compartment relay box
• Pull-in coil
• Red
• Start
• Starter clutch pedal position switch (on clutch pedal support)
• Starter motor
• Starter relay
• Starter solenoid
• Transmission range switch (lower left front of in top of transmission)