TRANSMISSION
3.2L
3.2L, Transmission Wiring Diagram for Isuzu Rodeo S 1993
List of elements for 3.2L, Transmission Wiring Diagram for Isuzu Rodeo S 1993:
- (brake pedal bracket)
- 1-2/3-4 shift solenoid
- 1-2/3-4 sol
- 1995 vftc c
- 2-3 shift solenoid
- 2-3 sol
- 5v ref
- A/c cut rly
- A/c on input
- Air conditioning system
- Automatic transmission mode switch (left side of transmission)
- Automatic transmission warning/indicator assembly
- Baro sens
- Barometric pressure sensor (high altitude vehicles only) (left side of engine compartment)
- Battery input
- Brake light switch
- Brake sw input
- C326
- C327
- Check trans indic
- Chk trans ind
- Coolant temp
- Cruise control system
- Dash fuse box (left i/p)
- Diag enable
- Diag output
- Ect sens
- Electronic ignition system
- Eng rpm input
- Eng rpm out
- Engine control module (left kick panel)
- Engine control module relay
- Exterior lights system
- Force motor (pressure regulator solenoid)
- Force mtr ctrl
- Fuse 1 15a
- Fuse 2 10a
- Fuse 5 10a
- Fuse 7 10a
- Fuse 8 10a
- Fuse/relay box (right engine compartment)
- G104 (rear of left front fender)
- G112 (ahead of starter)
- Ground
- Hot at all times
- Hot in on or start
- Ign input
- Ignition control module
- Illum.
- Interior lights system
- Kick down switch (behind left i/p)
- Kickdn sw
- N/a
- Nca
- Pnk
- Pnk/
- Power
- Power drive indic
- Power/winter switch
- Pwr drive ind
- Pwr mode enab
- Red
- Reference
- Starting/ charging system
- Tccs ctrl
- Throt pos sens
- Throttle position sensor (top left side of engine)
- Torque convertor clutch solenoid
- Tps input
- Trans oil temp
- Trans position
- Transmission
- Transmission control module (above left kick panel)
- Transmission control module diagnostic connector (left kick panel)
- Transmission oil temperature sensor
- Transmission speed sensor (left rear of transmission)
- Vss input
- Wint drive ind
- Wint mode enab
- Winter
- Winter drive indic